Manual Activation Laser Timeout - Trigger Settings - Honeywell Voyager 1250g User Manual

Do Not End Manual Activation
After Good Read Out-of-Stand

Manual Activation Laser Timeout - Trigger Settings

You can set a timeout for the length of time the laser remains on and attempting to
decode bar codes when the trigger is held down, and after it is released. Set the
length (in milliseconds) for a timeout by scanning one of the bar codes below, then
setting the timeout (from 1-65535 milliseconds) by scanning digits from the
Programming Chart
ms, Trigger Hold Out-of-Stand 30000 ms, Trigger Release In or Out-of-Stand 0.
Laser Timeout - Trigger Hold
Laser Timeout - Trigger Hold
Voyager 1250g User Guide
on page 202, then Save. Default = Trigger Hold In-Stand 5000
In-Stand
Out-of-Stand
* End Manual Activation After
Good Read Out-of-Stand
Laser Timeout - Trigger
Release In-Stand
Laser Timeout - Trigger
Release Out-of-Stand
49