Datalogic™ Magellan
Aux Port Configuration
Scan the following Plug and Play code to program the scanner for a Datalogic
Magellan bioptic scanner auxiliary port configuration. This bar code sets the baud
rate to 9600 bps and the data format to 8 data bits, no parity, 1 stop bit.
Note: If you are having unexpected results with this programming code, scan the Activate
Defaults bar code on
NCR Bioptic Aux Port Configuration
Scan the following Plug and Play code to program the scanner for an NCR bioptic
scanner auxiliary port configuration. This bar code sets the baud rate to 9600 bps
and the data format to 7 data bits, Even parity, 1 stop bit and Message RTS/CTS
with timeout. The following prefixes are programmed for each symbology:
Note: If you are having unexpected results with this programming code, scan the Activate
Defaults bar code on
16
©
Bioptic
Datalogic Magellan Bioptic Settings
page 149
first, then scan the programming bar code above.
Symbology
Prefix
UPC-A
A
UPC-E
E0
EAN-8
FF
EAN-13
F
Code 39
a
NCR Bioptic Settings
page 149
first, then scan the programming bar code above.
Symbology
Prefix
Interleaved 2 of 5
b
Code 128
f
r
GS1 DataBar
Omnidirectional
r
GS1 DataBar
Expanded
Codabar
N
Code 32
a
Pharmaceutical
(PARAF)
Voyager 1250g User Guide