Character Activation Mode; Activation Character - Honeywell Voyager 147 Series User Manual

Character Activation Mode

You may use a character sent from the host to trigger the scanner to begin scan-
ning. When the activation character is received, the scanner continues scanning
until either the
(see
barcode to use character activation, then use Activation Character (following) to
select the character you will send from the host to start scanning. Default = Off.

Activation Character

This sets the character used to trigger scanning when using Character Activation
Mode. On the
represents the character you want to use to trigger scanning. Scan the following
barcode, then use the
that represents that ASCII character. Scan Save to finish.
Voyager XP User Guide
Medium (2000ms)
Extra Long (4000ms)
Character Activation
Deactivation Character), or a barcode is transmitted. Scan the following On
* Off
ASCII Conversion Chart (Code Page
Programming Chart
Timeout, the deactivation character is received
1252), find the hex value that
to read the alphanumeric combination
Activation Character
Short (1000ms)
Long (3000ms)
On
85