Ncr Prefix; Ncr Suffix; Ncr Prefix/Suffix - Honeywell Voyager 1250g User Manual

NCR Prefix

This selection allows you to program an NCR-specific prefix. Refer to the
Conversion Chart (Code Page 1252)
characters you want for the NCR prefix (typically, 02 for STX). Scan the bar code
below, then set the hex number (from 0-FF) by scanning digits from the
Programming Chart

NCR Suffix

This selection allows you to program an NCR-specific suffix. Refer to the
Conversion Chart (Code Page 1252)
characters you want for the NCR suffix (typically, 03 for ETX). Scan the bar code
below, then set the hex number (from 0-FF) by scanning digits from the
Programming Chart

NCR Prefix/Suffix

When set to Transmit, both the NCR prefix and suffix are transmitted with bar
codes. Usually, prefixes and suffixes are programmed using the Data Editing selec-
tions (see
override any other prefix/suffix settings. Default = Don't Transmit.
Voyager 1250g User Guide
on page 202, then scanning Save. Default = 0.
on page 202, then scanning Save. Default = 0.
Data Edit beginning on page 61), however, the following commands
Transmit
on page 192 to find the hex equivalent for the
NCR Prefix
on page 192 to find the hex equivalent for the
NCR Suffix
Don't Transmit
ASCII
ASCII
* Don't Transmit
37