Usb Serial Commands; Usb Serial Emulation; Cts/Rts Emulation - Honeywell Voyager 1250g User Manual

Scan the bar code below, then set the length for the HID Fallback (from 0-60 min-
utes) by scanning digits from the
the

USB Serial Commands

USB Serial Emulation

Scan one of the following codes to program the scanner to emulate a regular
RS232-based COM Port. If you are using a Microsoft® Windows® PC, you will need
to download the USB serial driver from the Honeywell website
(www.honeywellaidc.com). The driver will use the next available COM Port number.
Apple® Macintosh computers recognize the scanner as a USB CDC class device
and automatically use a class driver.
Scanning either of these codes also adds a CR and LF.
Windows XP, Windows Server
Note: No extra configuration (e.g., baud rate) is necessary.

CTS/RTS Emulation

12
Save code. Default = 5 minutes.
USB Serial Emulation for
2003, and later
CTS/RTS Emulation On
Programming Chart
HID Fallback Mode
USB Serial Emulation for Windows 2000
on page 202, then scanning
* CTS/RTS Emulation Off
Voyager 1250g User Guide