Isbt 128 User-Defined Concatenation Sequences - Honeywell Voyager 1250g User Manual

Require Predefined Sequence

ISBT 128 User-Defined Concatenation Sequences

Note: You must enable Code 128 and ISBT 128 to use this feature.
The following bar codes are used to create a custom ISBT 128 Concatenation
Sequence. Select the identifiers you want to transmit in the 1st and 2nd positions,
both left and right. Refer to the ISBT 128 Standard Technical Specification for the
list of data identifiers.
Use the
the characters needed for the identifier. Locate the hex value for each character
and scan that 2 digit/character value from the
Example: You want to create a concatenation sequence that has the Donation Identification
Number (001) as the left identifier, and Product Code (003) as the right identifier.
The ISBT Index of Data Structures shows that for the Donation Identification
Number, the first character is "=" and the second character can be from A-N; P-Z; 1-
9. For this example, use "G." The Product Code first character is "=" and the second
character is "<."
Step 1.
Step 2.
Step 3.
Step 4.
Step 5.
Step 6.
Step 7.
Step 8.
Step 9.
Step 10. Scan the 2nd Right Identifier bar code, below.
Step 11. Use the
Step 12. Scan Save.
Once you have programmed the concatenation sequence, use
Defined Concatenation Sequences
Voyager 1250g User Guide
ASCII Conversion Chart (Code Page 1252),
Scan the 1st Left Identifier bar code, below.
Use the Programming Chart
Scan Save.
Scan the 2nd Left Identifier bar code, below.
Use the Programming Chart
Scan Save.
Scan the 1st Right Identifier bar code, below.
Use the Programming Chart
Scan Save.
Programming Chart
1st Left Identifier
beginning on page 192, to find
Programming Chart
to scan 3, D (hex for "=").
to scan 4, 7 (hex for "G").
to scan 3, D (hex for "=").
to scan 3, C (hex for "<").
to enable this feature. Default = 0.
on page 202.
ISBT 128 User-
109