Wincor Nixdorf Terminal Default Settings
Scan the following Plug and Play code to program the scanner for a Wincor Nixdorf
terminal. This bar code sets the baud rate to 9600 bps and the data format to 8
data bits, no parity, 1 stop bit.
Note: If you are having unexpected results with this programming code, scan the Activate
Defaults bar code on
Wincor Nixdorf Beetle™ Terminal Default Settings
Scan the following Plug and Play code to program the scanner for a Wincor Nixdorf
Beetle terminal. The following prefixes are programmed for each symbology:
Note: If you are having unexpected results with this programming code, scan the Activate
Defaults bar code on
Voyager 1250g User Guide
Wincor Nixdorf Terminal Settings
page 149
first, then scan the programming bar code above.
Symbology
Prefix
Aztec Code
V
Codabar
N
Code 93
L
Code 128
K
Data Matrix
R
EAN-8
B
EAN-13
A
GS1 DataBar
E
GS1-128
P
Wincor Nixdorf Beetle Settings
page 149
first, then scan the programming bar code above.
Symbology
Prefix
Interleaved 2 of 5
I
MaxiCode
T
MicroPDF417
S
PDF417
Q
QR Code
U
Straight 2 of 5 IATA
H
UPC-A
A0
UPC-E
C
All other bar codes
M
17