Stop Replacing Characters; Compare Characters; Compare String; Check For A Number - Honeywell Voyager 1250g User Manual

Stop replacing characters

E5 Terminates character replacement. Syntax = E5.

Compare characters

FE Compare the character in the current cursor position to the character "xx." If
characters are equal, move the cursor forward one position. Syntax = FExx where xx
stands for the comparison character's hex value for its ASCII code.
Refer to the
decimal, hex and character codes.

Compare string

B2 Compare the string in the input message to the string "s." If the strings are equal,
move the cursor forward past the end of the string. Syntax = B2nnnnS where nnnn
is the string length (up to 9999), and S consists of the ASCII hex value of each
character in the match string. For example, B2000454657374 will compare the
string at the current cursor position with the 4 character string "Test."
Refer to the
decimal, hex and character codes.

Check for a number

EC Check to make sure there is an ASCII number at the current cursor position. The
format is aborted if the character is not numeric.
EC Example: Only output the data if the bar code begins with a number
If you want only data from bar codes that begin with a number, you can use EC to
check for the number.
Command string: ECF10D
EC is the "Check for a number" command
F1 is the "Send all characters" command
0D is the hex value for a CR
If this bar code is read,
be used on the data. If there is no other format, the format fails and the raw data is
output as AB1234.
If this bar code is read:
1234AB
<CR>
Voyager 1250g User Guide
ASCII Conversion Chart (Code Page 1252),
ASCII Conversion Chart (Code Page 1252),
beginning on page 192 for
beginning on page 192 for
the next data format, if there is one, will
the data is output as:
81