Character Activation Mode; Activation Character - Honeywell Voyager 1450g Series User Manual

Medium (2000ms)
Extra Long (4000ms)

Character Activation Mode

You may use a character sent from the host to trigger the scanner to begin scanning. When the activation character is received,
the scanner continues scanning until either the
received (see Deactivation Character
acter activation, then use Activation Character (following) to select the character you will send from the host to start scanning.
Default = Off.
* Off

Activation Character

This sets the character used to trigger scanning when using Character Activation Mode. On the
(Code Page 1252), page A-3, find the hex value that represents the character you want to use to trigger scanning. Scan
the following bar code, then use the
character. Scan Save
Character Activation Laser Timeout
on page 4-12), or a bar code is transmitted. Scan the following On bar code to use char-
Programming Chart
to finish.
to read the alphanumeric combination that represents that ASCII
Activation Character
Short (1000ms)
Long (3000ms)
(page 4-12), the deactivation character is
ASCII Conversion Chart
On
4 - 11