Send All But The Last Characters; Insert A Character Multiple Times; Insert Symbology Name - Honeywell Voyager 1250g User Manual

44 is the hex value for a 'D"
0D is the hex value for a CR
The data is output as:
1234567890ABC
<CR>

Send all but the last characters

E9 Include in the output message all but the last "nn" characters, starting from the
current cursor position. The cursor is moved forward to one position past the last
input message character included. Syntax = E9nn where nn stands for the numeric
value (00-99) for the number of characters that will not be sent at the end of the
message.

Insert a character multiple times

F4 Send "xx" character "nn" times in the output message, leaving the cursor in the
current position. Syntax = F4xxnn where xx stands for the insert character's hex
value for its ASCII code, and nn is the numeric value (00-99) for the number of times
it should be sent. Refer to the
on page 192 for decimal, hex and character codes.
E9 and F4 Example: Send all but the last characters, followed by 2 tabs
Send all characters except for the last 8 from the bar code above, followed by 2
tabs.
Command string: E908F40902
E9 is the "Send all but the last characters" command
08 is the number of characters at the end to ignore
F4 is the "Insert a character multiple times" command
09 is the hex value for a horizontal tab
02 is the number of times the tab character is sent
The data is output as: 1234567890AB <tab><tab>

Insert symbology name

B3 Insert the name of the bar code's symbology in the output message, without moving
the cursor. Only symbologies with a Honeywell ID are included (see
Charts
beginning on page 192 for decimal, hex and character codes.
74
on page 189). Refer to the
ASCII Conversion Chart (Code Page 1252),
ASCII Conversion Chart (Code Page 1252),
beginning
Symbology
Voyager 1250g User Guide