Replace Cables; Replace An Interface Cable; Troubleshoot A Voyager Scanner - Honeywell Voyager 1250g User Manual

Replace Cables

The standard interface cable is attached to the scanner with an 10-pin modular
connector. When properly seated, the connector is held in the scanner's handle by
a flexible retention tab. The interface cable is designed to be field replaceable.
•
•

Replace an Interface Cable

1. Turn off the power to the host system.
2. Disconnect the scanner's cable from the terminal or
3. Locate the small hole on the underside of the scanner's
4. Straighten one end of a paper clip.
5. Insert the end of the paper clip into the small hole and
6. Replace with the new cable.

Troubleshoot a Voyager Scanner

The scanner automatically performs self-tests whenever you turn it on. If your
scanner is not functioning properly, review the following Troubleshooting Guide to
try to isolate the problem.
Is the power on? Is the laser aimer on?
If the laser aimer isn't illuminated, check that:
•
•
•
Is the scanner having trouble reading your symbols?
If the scanner isn't reading symbols well, check that the scanner window is clean
and that the symbols:
•
186
Order replacement cables from Honeywell or from an authorized distributor.
When ordering a replacement cable, specify the cable part number of the
original interface cable.
computer.
handle. This is the cable release.
press in. This depresses the retention tab, releasing the
connector. Pull the connector out while maintaining
pressure on the paper clip, then remove the paper clip.
Insert the connector into the opening and press firmly. The connector is keyed
to go in only one way, and will click into place.
The cable is connected properly.
The host system power is on (if external power isn't used).
The trigger works.
Aren't smeared, rough, scratched, or exhibiting voids.
Cable
Release
Voyager 1250g User Guide