Extra Long (4000ms)
Character Activation Mode
You may use a character sent from the host to trigger the scanner to begin scanning. When the activation character is received,
the scanner continues scanning until either the
following On bar code to use character activation, then use Activation Character (following) to select the character you will send
from the host to start scanning. Default = Off.
* Off
End Character Activation After Good Read
After a bar code is successfully detected and read from the scanner, the illumination can be programmed either to remain
on and scanning, or to turn off. When End Character Activation After Good Read is enabled, the illumination turns off
and stops scanning after a good read. If you scan Do Not End Character Activation After Good Read, the illumination
remains on after a good read. Default = Do Not End Character Activation After Good Read.
* Do Not End Character
Activation After Good Read
Character Activation Timeout
Long (3000ms)
(page 3-8) or a bar code is transmitted. Scan the
End Character Activation After
On
Good Read
3 - 7