Plessey Redundancy; Plessey Message Length - Honeywell Voyager 1250g User Manual

When Check Character is set to Validate and Transmit, the scanner only reads
Plessey bar codes printed with a check character, and will transmit this character at
the end of the scanned data. Default = No Check Character.

Plessey Redundancy

If you are encountering errors when reading Plessey bar codes, you may want to
adjust the redundancy count. Redundancy adjusts the number of times a bar code
is decoded before transmission, which may reduce the number of errors. Note that
the higher the redundancy count, the longer it will take to decode the bar code. To
adjust the redundancy, scan the Plessey Redundancy bar code below, then scan a
redundancy count between 0 and 10 on the
Then scan the

Plessey Message Length

Scan the bar codes below to change the message length. Refer to
Description
= 1-80. Minimum Default = 3, Maximum Default = 80.
Minimum Message Length
Voyager 1250g User Guide
* No Check Character
Validate and Transmit
Save bar code. Default = 0.
(page 88) for additional information. Minimum and Maximum lengths
Programming Chart
Plessey Redundancy
Validate, but Don't Transmit
on page 202.
Message Length
Maximum Message Length
139