Nec 2 Of 5 Redundancy; Nec 2 Of 5 Message Length; Code 93 - Honeywell Voyager 1250g User Manual

NEC 2 of 5 Redundancy

If you are encountering errors when reading NEC 2 of 5 bar codes, you may want to
adjust the redundancy count. Redundancy adjusts the number of times a bar code
is decoded before transmission, which may reduce the number of errors. Note that
the higher the redundancy count, the longer it will take to decode the bar code. To
adjust the redundancy, scan the NEC 2 of 5 Redundancy bar code below, then
scan a redundancy count between 0 and 10 on the
202. Then scan the

NEC 2 of 5 Message Length

Scan the bar codes below to change the message length. Refer to
Description
= 1-80. Minimum Default = 3, Maximum Default = 80.
Minimum Message Length

Code 93

Code 93 On/Off
98
Save bar code. Default = 0.
(page 88) for additional information. Minimum and Maximum lengths
< Default All Code 93 Settings >
* On
NEC 2 of 5 Redundancy
Programming Chart
Message Length
Maximum Message Length
Off
Voyager 1250g User Guide
on page