To Add A Data Format - Honeywell Voyager 1250g User Manual

If you have changed data format settings, and wish to clear all formats and return
to the factory defaults, scan the Default Data Format code below.

To Add a Data Format

Step 1.
Step 2.
Step 3.
Note: 099 indicates all terminal types.
Step 4.
Note: 99 indicates all symbologies.
Step 5.
Note: 9999 indicates all lengths.
Step 6.
70
Scan the Enter Data Format symbol
Select Primary/Alternate Format
Determine if this will be your primary data format, or one of 3 alternate
formats. This allows you to save a total of 4 different data formats. To
program your primary format, scan 0 from the
beginning on page 202. If you are programming an alternate format,
scan 1, 2, or 3, depending on which alternate format you are
programming. (See "Primary/Alternate Data Formats" on page 84 for
further information.)
Terminal Type
Refer to Terminal ID Table
for your PC. Scan three numeric bar codes from the
beginning on page 202, to program the scanner for your terminal ID (you
must enter 3 digits). For example, scan 0 0 3 for an AT wedge.
Code I.D.
In the Symbology Charts,
which you want to apply the data format. Locate the Hex value for that
symbology and scan the 2 digit hex value from the
beginning on page 202.
If you are creating a data format for Batch Mode Quantity, use 35 for the
Code I.D.
Length
Specify what length (up to 9999 characters) of data will be acceptable for
this symbology. Scan the four digit data length from the
Chart, beginning on page 202. For example, 50 characters is entered as
0050.
Editor Commands
Refer to Data Format Editor Commands
represent the command you want to enter.
* Default Data Format
(page
(page 72) and locate the Terminal ID number
beginning on page 189, find the symbology to
(page 72). Scan the symbols that
71).
Programming Chart,
Programming Chart,
Programming Chart,
Programming
Voyager 1250g User Guide