128 Group Separator Output
If you wish to transmit the group separator characters "GS" (0x1D hex) with your
Code 128 bar code output, scan the On bar code. When Off is scanned, the group
separator is not output. Default =Off.
Code 128 Redundancy
If you are encountering errors when reading Code 128 bar codes, you may want to
adjust the redundancy count. Redundancy adjusts the number of times a bar code
is decoded before transmission, which may reduce the number of errors. Note that
the higher the redundancy count, the longer it will take to decode the bar code. To
adjust the redundancy, scan the Code 128 Redundancy bar code below, then scan
a redundancy count between 0 and 10 on the
Then scan the
Code 128 Message Length
Scan the bar codes below to change the message length. Refer to
Description
= 1-80. Minimum Default = 1, Maximum Default = 80.
Minimum Message Length
106
On
Save
bar code. Default = 0.
(page 88) for additional information. Minimum and Maximum lengths
Programming Chart
Code 128 Redundancy
* Off
on page 202.
Message Length
Maximum Message Length
Voyager 1250g User Guide