last set of bar code data is retransmitted and the scanner waits for ACK/NAK again.
Turn on the ACK/NAK protocol by scanning the ACK/NAK On bar code below. To
turn off the protocol, scan ACK/NAK Off. Default = ACK/NAK Off.
Communication Timeout
This allows you to set the length (in milliseconds) for a timeout for the host ACK/
NAK response. Scan the bar code below, then set the timeout (from 1-65535 milli-
seconds) by scanning digits from the
ning Save. Default = 2000 ms.
Voyager 1250g User Guide
ACK/NAK On
Programming Chart
Communication Timeout
* ACK/NAK Off
on page 202, then scan-
39