Character Activation Laser Timeout; Character Deactivation Mode; Deactivation Character; Output Sequence Overview - Honeywell Stratos 2700 User Manual

Character Activation Laser Timeout

You can set a timeout for the length of time the laser remains on and attempting to decode bar codes when using Character
Activation Mode. Set the length (in milliseconds) for a timeout by scanning the following bar code, then setting the timeout
(from 1-65535 milliseconds) by scanning digits from the
scanning Save. Default = 5000 ms.

Character Deactivation Mode

If you have sent a character from the host to trigger the scanner to begin scanning, you can also send a deactivation character
to stop scanning. Scan the following On bar code to use character deactivation, then use Deactivation Character (following) to
select the character you will send from the host to terminate scanning. Default = Off.
* Off

Deactivation Character

This sets the character used to terminate scanning when using Character Deactivation Mode. On the
Chart (Code Page 1252), page A-3, find the hex value that represents the character you want to use to terminate scanning.
Scan the following bar code, then use the
meric combination that represents that ASCII character. Scan

Output Sequence Overview

Require Output Sequence

When turned off, the bar code data will be output to the host as the scanner decodes it. When turned on, all output data
must conform to an edited sequence or the scanner will not transmit the output data to the host device.
4 - 16
Programming Chart
Character Activation Laser
Timeout
Programming Chart inside the back cover of this manual to read the alphanu-
Save
Deactivation Character
inside the back cover of this manual, then
to finish.
On
ASCII Conversion