Manual Activation Laser Timeout - Trigger Settings
You can set a timeout for the length of time the laser remains on and attempting to decode bar codes when the trigger is
held down, and after it is released. Set the length (in milliseconds) for a timeout by scanning one of the following bar codes,
then setting the timeout (from 1-65535 milliseconds) by scanning digits from the
Default = Trigger Hold Out-of-Stand 30,000 ms, Trigger Release Out-of-Stand 0.
Laser Timeout - Trigger Hold
Out-of-Stand
Reread Delay
This sets the time period before the scanner can read the same bar code a second time. Setting a reread delay protects against
accidental rereads of the same bar code. Longer delays are effective in minimizing accidental rereads. Use shorter delays in
applications where repetitive bar code scanning is required. Reread Delay only works when in a
3-10). Default = Medium.
Short (500 ms)
Long (1000 ms)
User-Specified Reread Delay
If you want to set your own length for the reread delay, scan the bar code below, then set the delay (from 0-30,000 millisec-
onds) by scanning digits from the inside back cover, then scanning Save.
User-Specified Reread Delay
Programming
Chart, then scanning Save.
Laser Timeout - Trigger
Release Out-of-Stand
Presentation Mode
* Medium (750 ms)
Extra Long (2000 ms)
(see page
3 - 11