Good Read Delay
This sets the minimum amount of time before the scanner can read another bar
code. Default = No Delay.
* No Delay
Short Delay (500 ms)
Medium Delay (1000 ms)
Long Delay (1500 ms)
User-Specified Good Read Delay
If you want to set your own length for the good read delay, scan the bar code
below, then set the delay (from 0-30,000 milliseconds) by scanning digits from
the
Programming Chart
inside back cover, then scanning Save.
User-Specified Good Read Delay
Trigger Modes
Manual/Serial Trigger
You can activate the scanner either by pressing the trigger, or using a serial trig-
ger command (see
Trigger Commands
on page 9-4). When in manual trigger
mode, the scanner scans until a bar code is read, or until the trigger is released.
3 - 5