Character Activation Timeout; Character Deactivation Mode; Deactivation Character; Illumination Lights - Honeywell HF680 Series User Manual

Character Activation Timeout

You can set a timeout for the length of time the aimer remains on and attempting
to decode barcodes when using
milliseconds) for a timeout by scanning the following barcode, then setting the
timeout (from 1-65535 milliseconds) by scanning digits from the
Chart, then scanning Save. Default = 5000 ms.

Character Deactivation Mode

If you have sent a character from the host to trigger the scanner to begin scanning,
you can also send a deactivation character to stop scanning. Scan the following On
barcode to use character deactivation, then use
the character you will send from the host to terminate scanning. Default = Off.

Deactivation Character

This sets the character used to terminate scanning when using Character
Deactivation Mode. On the
value that represents the character you want to use to terminate scanning. Scan
the following barcode, then use the
combination that represents that ASCII character. Scan Save to finish.

Illumination Lights

If you want the illumination lights on while reading a barcode, scan the Lights On
barcode, below. However, if you want to turn just the lights off, scan the Lights Off
barcode. Default = Lights On.
42
* Off
ASCII Conversion Chart (Code Page
Character Activation
Character Activation Timeout
Deactivation Character
Programming Chart
Deactivation Character
Mode. Set the length (in
Programming
to select
On
1252), find the hex
to read the alphanumeric
HF680 Series User Guide