Broadcast Storm Control Commands - D-Link DGS-3212SR Command Line Interface Reference Manual

12-port gigabit layer 2 stackable switch
Hide thumbs Also See for DGS-3212SR:
Table of Contents

Advertisement

The broadcast storm control commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters)
in the following table.
Command
config traffic control
show traffic control
Each command is listed, in detail, in the following sections.
config traffic control
Purpose
Syntax
Description
Parameters
DGS-3212SR Layer 3 Gigabit Switch
B
ROADCAST
Parameters
[<storm_grouplist> | all ] {broadcast [enable | disable] | multicast
[enable | disable] | dlf [enable | disable] | threshold <value 0-
255> }
{group_list <storm_grouplist>}
NOTE: As a stand-alone switch or as a master switch in a switch stack,
the switch number will be referred to as 15 for all configurations, graphs
and tables.
Used to configure broadcast/multicast traffic control.
config traffic control [<storm_grouplist> | all] {broadcast
[enable | disable] | multicast [enable | disable] | dlf [enable |
disable] | threshold <value 0-255>}
This command is used to configure broadcast storm control.
<storm_grouplist> − Used to specify a broadcast storm control
group. This is specified by listing the lowest switch number and
the beginning port number on that switch, separated by a colon.
Then the highest switch number, and the highest port number of
the range (also separated by a colon) are specified. The beginning
and end of the port list range are separated by a dash. For
example, 1:3 specifies switch number 1, port 3. 2:4 specifies
switch number 2, port 4. 1:3-2:4 specifies all of the ports between
switch 1, port 3 and switch 2, port 4 − in numerical order.
all − Specifies all broadcast storm control groups on the switch.
broadcast [enable | disable] − Enables or disables broadcast
storm control.
multicast [enable | disable] − Enables or disables multicast storm
control.
dlf [enable | disable] − Enables or disables dlf traffic control.
threshold <value 0-255> − The upper threshold at which the
specified traffic control is switched on. The <value> is the number
of broadcast / multicast / dlf packets, in Kbps, received by the
S
C
TORM
ONTROL
102
12
C
OMMANDS

Advertisement

Table of Contents
loading

Table of Contents