D-Link DGS-3212SR Command Line Interface Reference Manual page 54

DGS-3212SR:4#
show snmp engineID
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the current name of the SNMP engine on the switch:
DGS-3212SR:4#show snmp engineID
Command: show snmp engineID
SNMP Engine ID : 0035636666
DGS-3212SR:4#
create snmp group
Purpose
Syntax
Description
Parameters
DGS-3212SR Layer 3 Gigabit Switch
Used to display the identification of the SNMP engine on the
switch.
show snmp engineID
The show snmp engineID command displays the identification
of the SNMP engine on the switch.
None.
Only administrator-level users can issue this command.
Used to create a new SNMP group, or a table that maps SNMP
users to SNMP views.
create snmp group <groupname 32> [v1 | v2c | v3
[noauth_nopriv | auth_nopriv | auth_priv]] {read_view
<view_name 32> | write_view <view_name 32> | notify_view
<view_name 32>}
The create snmp group command creates a new SNMP group,
or a table that maps SNMP users to SNMP views.
<groupname 32> − An alphanumeric name of up to 32 characters
that will identify the SNMP group the new SNMP user will be
associated with.
v1 – Specifies that SNMP version 1 will be used. The Simple
Network Management Protocol (SNMP), version 1, is a network
management protocol that provides a means to monitor and
control network devices.
v2c – Specifies that SNMP version 2c will be used. The SNMP
v2c supports both centralized and distributed network
42