D-Link DGS-3212SR Command Line Interface Reference Manual page 141

config link_aggregation algorithm
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure link aggregation algorithm for mac-source-dest:
DGS-3212SR:4#config link_aggregation algorithm mac_source_dest
Command: config link_aggregation algorithm mac_source_dest
Success.
DGS-3212SR:4#
show link_aggregation
Purpose
Syntax
Description
DGS-3212SR Layer 3 Gigabit Switch
Used to configure the link aggregation algorithm.
config link_aggregation algorithm [mac_source |
mac_destination | mac_source_dest | ip_source |
ip_destination | ip_source_dest]
This command configures to part of the packet examined by the
switch when selecting the egress port for transmitting load-sharing
data. This feature is only available using the address-based load-
sharing algorithm.
mac_source − Indicates that the switch should examine the MAC
source address.
mac_destination − Indicates that the switch should examine the
MAC destination address.
mac_source_dest − Indicates that the switch should examine the
MAC source and destination addresses
ip_source − Indicates that the switch should examine the IP source
address.
ip_destination − Indicates that the switch should examine the IP
destination address.
ip_source_dest − Indicates that the switch should examine the IP
source address and the destination address.
Only administrator-level users can issue this command.
Used to display the current link aggregation configuration on the
switch.
show link_aggregation {group_id <value 1-6> | algorithm}
This command will display the current link aggregation configuration
of the switch.
129