D-Link DGS-3212SR Command Line Interface Reference Manual page 150

enable igmp_snooping
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable IGMP snooping on the switch:
DGS-3212SR:4#enable igmp_snooping
Command: enable igmp_snooping
Success.
DGS-3212SR:4#
disable igmp_snooping
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable IGMP snooping on the switch:
DGS-3212SR Layer 3 Gigabit Switch
Used to enable IGMP snooping on the switch.
enable igmp_snooping {forward_mcrouter_only}
This command allows you to enable IGMP snooping on the
switch. If forward_mcrouter_only is specified, the switch will only
forward all multicast traffic to the multicast router, only.
Otherwise, the switch forwards all multicast traffic to any IP
router.
forward_mcrouter_only − Specifies that the switch should only
forward all multicast traffic to a multicast-enabled router.
Otherwise, the switch will forward all multicast traffic to any IP
router.
Only administrator-level users can issue this command.
Used to enable IGMP snooping on the switch.
disable igmp_snooping
This command disables IGMP snooping on the switch. IGMP
snooping can be disabled only if IP multicast routing is not being
used. Disabling IGMP snooping allows all IGMP and IP multicast
traffic to flood within a given IP interface. If forward_mcrouter_only
is specified, the switch will discontinue forwarding all multicast
traffic to the multicast router.
None.
Only administrator-level users can issue this command.
138