D-Link DGS-3212SR Command Line Interface Reference Manual page 140

config link_aggregation
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To define a load-sharing group of ports, group-id 1,master port 5 of module 1 with group members ports 5-7 plus port
9:
DGS-3212SR:4#config link_aggregation group_id 1 master_port 1:5
ports 1:5-1:7, 1:9
Command: config link_aggregation group_id 1 master_port 1:5 ports
1:5-1:7, 1:9
Success.
DGS-3212SR:4#
DGS-3212SR Layer 3 Gigabit Switch
Used to configure a previously created link aggregation group.
config link_aggregation group_id <value 1-6> {master_port
<port> | ports <portlist> | state [enable | disable]
This command allows you to configure a link aggregation group that
was created with the create link_aggregation command above.
The DGS-3212SR supports link aggregation cross box which
specifies that link aggregation groups may be spread over multiple
switches in the switching stack.
group _id <value 1-6> − Specifies the group ID. The switch allows
up to 6 link aggregation groups to be configured. The group number
identifies each of the groups.
master_port<port> − Master port ID. Specifies which port (by port
number) of the link aggregation group will be the master port. All of
the ports in a link aggregation group will share the port configuration
with the master port.
ports <portlist> − Specifies a range of ports that will belong to the
link aggregation group. The port list is specified by listing the lowest
switch number and the beginning port number on that switch,
separated by a colon. Then the highest switch number, and the
highest port number of the range (also separated by a colon) are
specified. The beginning and end of the port list range are separated
by a dash. For example, 1:3 specifies switch number 1, port 3. 2:4
specifies switch number 2, port 4. 1:3-2:4 specifies all of the ports
between switch 1, port 3 and switch 2, port 4 − in numerical order.
state [enable | disable] − Allows you to enable or disable the
specified link aggregation group.
Only administrator-level users can issue this command. Link
aggregation groups may not overlap.
128