D-Link DGS-3212SR Command Line Interface Reference Manual page 143

config lacp_ports
Restrictions
Example usage:
To configure LACP port mode settings:
DGS-3212SR:4#config lacp_port 1
Command: config lacp_port 1
Success.
DGS-3212SR:4#
show lacp_port
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display LACP port mode settings:
DGS-3212SR Layer 3 Gigabit Switch
active – Active LACP ports are capable of processing and
sending LACP control frames. This allows LACP compliant
devices to negotiate the aggregated link so the group may be
changed dynamically as needs require. In order to utilize the
ability to change an aggregated port group, that is, to add or
subtract ports from the group, at least one of the participating
devices must designate LACP ports as active. Both devices
must support LACP.
passive – LACP ports that are designated as passive
cannot process LACP control frames. In order to allow the
linked port group to negotiate adjustments and make
changes dynamically, at one end of the connection must
have "active" LACP ports (see above).
Only administrator-level users can issue this command.
1-1
:
1-1 12 mode active
: :
Used to display current LACP port mode settings.
show lacp_port {<portlist>}
This command will display the LACP mode settings as they are
currently configured.
<portlist> - Specifies a range of ports that will be viewed. The port
list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon. Then
the highest switch number, and the highest port number of the range
(also separated by a colon) are specified. The beginning and end of
the port list range are separated by a dash. For example, 1:3
specifies switch number 1, port 3. 2:4 specifies switch number 2,
port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and
switch 2, port 4 − in numerical order.
Only administrator-level users can issue this command.
131
12 mode active
: