D-Link DGS-3212SR Command Line Interface Reference Manual page 142

show link_aggregation
Parameters
Restrictions
Example usage:
To display Link Aggregation configuration:
DGS-3212SR:4#show link_aggregation
Command: show link_aggregation
Link Aggregation Algorithm = MAC-source-dest
Group ID
Master Port
Member Port
Active Port:
Status
Flooding Port
DGS-3212SR:4
config lacp_ports
Purpose
Syntax
Description
Parameters
DGS-3212SR Layer 3 Gigabit Switch
group_id <value 1-6> − Specifies the group ID. The switch allows up
to 6 link aggregation groups to be configured. The group number
identifies each of the groups.
algorithm − Allows you to specify the display of link aggregation by
the algorithm in use by that group.
None.
: 1
: 2:10
: 1:5-1:10,2:10
: Disabled
: 1:5
Used to configure settings for LACP compliant ports.
config lacp_ports <portlist> mode [active | passive]
This command is used to configure ports that have been
previously designated as LACP ports (see create
link_aggregation).
<portlist> − Specifies a range of ports to be configured. The port
list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon. Then
the highest switch number, and the highest port number of the
range (also separated by a colon) are specified. The beginning
and end of the port list range are separated by a dash. For
example, 1:3 specifies switch number 1, port 3. 2:4 specifies
switch number 2, port 4. 1:3-2:4 specifies all of the ports between
switch 1, port 3 and switch 2, port 4 − in numerical order.
mode – Select the mode to determine if LACP ports will process
LACP control frames.
130