D-Link DGS-3212SR Command Line Interface Reference Manual page 119

config bandwidth_control
Restrictions
Example usage:
To configure bandwidth control:
DGS-3212SR:4#config bandwidth_control 1:1-1:10 tx_rate 10
Command: config bandwidth_control 1:1-1:10 tx_rate 10
Success.
DGS-3212SR:4#
show bandwidth_control
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display bandwidth control settings:
DGS-3212SR:4#show bandwidth_control 1:1-1:10
Command: show bandwidth_control 1:1-1:10
Bandwidth Control Table
DGS-3212SR Layer 3 Gigabit Switch
<value 1-1000> − Specifies the packet limit, in Mbps, that
the above ports will be allowed to receive.
Only administrator-level users can issue this command.
Used to display the bandwidth control configuration on the switch.
show bandwidth_control {<portlist>}
The show bandwidth_control command displays the current
bandwidth control configuration on the switch, on a port-by-port
basis.
<portlist> − Specifies a range of ports to be configured. The port
list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon. Then
the highest switch number, and the highest port number of the
range (also separated by a colon) are specified. The beginning
and end of the port list range are separated by a dash. For
example, 1:3 specifies switch number 1, port 3. 2:4 specifies
switch number 2, port 4. 1:3-2:4 specifies all of the ports between
switch 1, port 3 and switch 2, port 4 − in numerical order.
Using this command without adding a portlist entry will show the
bandwidth control for all ports in the switch stack.
None.
107