D-Link DGS-3212SR Command Line Interface Reference Manual page 226

config access_profile profile_id
Parameters
DGS-3212SR Layer 3 Gigabit Switch
profile_id <value 1-255> − Enter an integer between 1 and 255 that is
used to identify the access profile that will be deleted with this
command. This value is assigned to the access profile when it is
created with the create access_profile command.
add access_id <value 1-255> − Adds an additional rule to the above
specified access profile. The value specifies the relative priority of the
additional rule. The lower access ID, the higher the priority the rule will
be given.
ethernet − Specifies that the switch will look only into the layer 2 part
of each packet.
vlan <vlan_name 32> − Specifies that the access profile will
•
apply to only to this VLAN.
source_mac <macaddr> − Specifies that the access profile will
•
apply to only packets with this source MAC address.
destination_mac <macaddr> − Specifies that the access profile
•
will apply to only packets with this destination MAC address.
802.1p <value 0-7> − Specifies that the access profile will apply
•
only to packets with this 802.1p priority value.
ethernet_type <hex 0x0-0xffff> − Specifies that the access
•
profile will apply only to packets with this hexadecimal 802.1Q
Ethernet type value in the packet header.
ip − Specifies that the switch will look into the IP fields in each packet.
vlan <vlan_name 32> − Specifies that the access profile will
•
apply to only to this VLAN.
source_ip <ipaddr> − Specifies that the access profile will apply
•
to only packets with this source IP address.
destination_ip <ipaddr> − Specifies that the access profile will
•
apply to only packets with this destination IP address.
dscp <value 0-63> − Specifies that the access profile will apply
•
only to packets that have this value in their Type-of-Service
(DiffServ code point, DSCP) field in their IP packet header.
icmp − Specifies that the switch will examine the Internet Control
•
Message Protocol (ICMP) field within each packet.
type <value 0-255> − Specifies that the access profile will
•
apply to this ICMP type value.
code <value 0-255> − Specifies that the access profile will
•
apply to this ICMP code.
214