D-Link DGS-3212SR Command Line Interface Reference Manual page 244

12-port gigabit layer 2 stackable switch
Hide thumbs Also See for DGS-3212SR:
Table of Contents

Advertisement

config sim
Purpose
Syntax
Description
Parameters
Restrictions
To change the time interval of the discovery protocol:
DGS-3212SR Layer 3 Gigabit Switch
Used to configure role parameters for the SIM protocol on the
switch.
config sim [{[ commander {group_name <groupname 64> |
candidate] | dp_interval <30-90> | hold_time <sec 100-255>}]
This command is used to configure parameters of switches of the
SIM.
commander – Use this parameter to configure the commander
switch for the following parameters:
group_name <groupname 64> - Used to update the name
of the group. Enter an alphanumeric string of up to 64
characters to rename the SIM group.
dp_interval <30-90> – The user may set the discovery
protocol interval, in seconds that the switch will send out
discovery packets. Returning information to the commander
switch will include information about other switches
connected to it. (Ex. MS, CaS). The user may set the
discovery protocol interval from 30 to 90 seconds.
hold time <sec 100-255> – Using this parameter, the user
may set the time, in seconds, the switch will hold
information sent to it from other switches, utilizing the
discovery interval protocol. The user may set the hold time
from 100 to 300 seconds.
candidate – Used to change the role of a commander switch to a
candidate switch.
dp_interval <30-90>– The user may set the discovery
protocol interval, in seconds that the switch will send out
discovery packets. Returning information to the commander
switch will include information about other switches
connected to it. (Ex. MS, CaS). The user may set the dp
interval from 30 to 90 seconds.
hold time <sec 100-255>– Using this parameter, the user
may set the time, in seconds, the switch will hold
information sent to it from other switches, utilizing the
discovery interval protocol. The user may set the hold time
from 100 to 300 seconds.
Only administrator-level users can issue this command.
DGS-3212SR:4#config sim commander dp_interval 30
Command:config sim commander dp_interval 30
Success.
232

Advertisement

Table of Contents
loading

Table of Contents