D-Link DGS-3212SR Command Line Interface Reference Manual page 225

Command: delete access_profile profile_id 1
Success.
DGS-3212SR:4#
config access_profile profile_id
Purpose
Syntax
Description
DGS-3212SR Layer 3 Gigabit Switch
Used to configure an access profile on the switch and to define
specific values that will be used to by the switch to determine if a given
packet should be forwarded or filtered. Masks entered using the
create access_profile command will be combined, using a logical
AND operation, with the values the switch finds in the specified frame
header fields. Specific values for the rules are entered using the
config access_profile command, below.
config access_profile profile_id <value 1-255>[ add access_id
<value 1-255>[ ethernet { vlan <vlan_name 32> |
<macaddr> | destination_mac <macaddr> |
| ethernet_type <hex 0x0-0xffff> }[ permit { priority <value 0-7>
{ replace_priority}} | deny ]| ip{ vlan <vlan_name 32> |
source_ip <ipaddr> | destination_ip <ipaddr> |
63> |[ icmp {type <value 0-255> code <value 0-255>} |
{type <value 0-255>} |
<value 0-65535> | flag_mask [all | {urg | ack | psh | rst| syn | fin}]} |
udp {src_port <value 0-65535> | dst_port <value 0-65535>}|
protocol_id <value 0 - 255> {user_define <hex 0x0-
0xffffffff>}]}[ permit{priority <value 0-7> { replace_priority} |
replace_dscp <value 0-63> } | deny ]|packet_content{offset_0-15
<hex 0x0-0xffffffff><hex 0x0-0xffffffff><hex 0x0-0xffffffff><hex
0x0-0xffffffff> | offset_16-31 <hex 0x0-0xffffffff><hex 0x0-
0xffffffff><hex 0x0-0xffffffff><hex 0x0-0xffffffff> | offset_32-47
<hex 0x0-0xffffffff><hex 0x0-0xffffffff><hex 0x0-0xffffffff><hex
0x0-0xffffffff> | offset_48-63 <hex 0x0-0xffffffff><hex 0x0-
0xffffffff><hex 0x0-0xffffffff><hex 0x0-0xffffffff> |offset_64-79
<hex 0x0-0xffffffff><hex 0x0-0xffffffff><hex 0x0-0xffffffff><hex
0x0-0xffffffff>}[ permit{ priority <value 0-7> } | deny ] ]| delete
access_id <value 1-255> ]
The config access_profile command is used to configure an access
profile on the switch and to enter specific values that will be combined,
using a logical AND operation, with masks entered with the create
access_profile command, above.
213
tcp {src_port <value 0-65535> | dst_port
source_mac
802.1p <value 0-7>
dscp <value 0-
igmp