D-Link DGS-3212SR Command Line Interface Reference Manual page 215

config 802.1x reauth
Restrictions
Example usage:
To configure 802.1x reauthentication for ports 1-10:
DGS-3212SR:4#config 802.1x reauth port_based ports 1:1-1:18
Command: config 802.1x reauth port_based ports 1:1-1:18
Success.
DGS-3212SR:4#
config radius add
Purpose
Syntax
Description
Parameters
DGS-3212SR Layer 3 Gigabit Switch
specifies switch number 2, port 4. 1:3-2:4 specifies all of the
ports between switch 1, port 3 and switch 2, port 4 − in
numerical order.
all − Specifies all of the ports on the switch.
mac-based - This instructs the switch to re-authorize 802.1x
function based on a specific MAC address. Ports approved for re-
authorization can then be specified.
<portlist> − Specifies a range of ports. The port list is
specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon.
Then the highest switch number, and the highest port number
of the range (also separated by a colon) are specified. The
beginning and end of the port list range are separated by a
dash. For example, 1:3 specifies switch number 1, port 3. 2:4
specifies switch number 2, port 4. 1:3-2:4 specifies all of the
ports between switch 1, port 3 and switch 2, port 4 − in
numerical order.
all − Specifies all of the ports on the switch.
mac_address <macaddr> - Specifies the MAC address of the
client the user wishes to add.
Only administrator-level users can issue this command.
Used to add a new RADIUS server.
config radius add <server_index 1-3> <server_ip> key
<passwd 32> [default | {auth_port <udp_port_number 1-
65535> | acct_port <udp_port_number 1-65535>}]
The config radius add command is used to add RADIUS
servers to the switch.
<server_index 1-3> − Assigns a number to the current set of
RADIUS server settings. Up to 3 groups of RADIUS server
settings can be entered on the switch. The lowest index number
203