D-Link DGS-3212SR Command Line Interface Reference Manual page 74

DGS-3212SR:4#show utilization unit_id 1
Port
----
1:1
1:2
1:3
1:4
1:5
1:6
1:7
1:8
1:9
1:10
1:11
1:12
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
To display the current cpu utilization:
DGS-3212SR:4#show utilization cpu
Command: show utilization cpu
CPU utilization :
-------------------------------------------------------------------------------
Five seconds - 15%
DGS-3212SR:4#
clear counters
Purpose
Syntax
Description
Parameters
DGS-3212SR Layer 3 Gigabit Switch
TX/sec RX/sec Util
---------- ---------- ----
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
One minute - 25%
Used to clear the switch's statistics counters.
clear counters {ports <portlist>}
This command will clear the counters used by the switch to compile
statistics.
<portlist> − Specifies a range of ports to be configured. The port list
is specified by listing the lowest switch number and the beginning
port number on that switch, separated by a colon. Then the highest
switch number, and the highest port number of the range (also
separated by a colon) are specified. The beginning and end of the
port list range are separated by a dash. For example, 1:3 specifies
switch number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-
2:4 specifies all of the ports between switch 1, port 3 and switch 2,
Port TX/sec RX/sec Util
---- ---------- ----------
Five minutes - 14%
62
----