D-Link DGS-3212SR Command Line Interface Reference Manual page 207

show 802.1x auth_configuration
Parameters ports <portlist> − Specifies a range of ports. The port list is specified
by listing the lowest switch number and the beginning port number on
that switch, separated by a colon. Then the highest switch number,
and the highest port number of the range (also separated by a colon)
are specified. The beginning and end of the port list range are
separated by a dash. For example, 1:3 specifies switch number 1,
port 3. 2:4 specifies switch number 2, port 4. 1:3-2:4 specifies all of
the ports between switch 1, port 3 and switch 2, port 4 − in numerical
order.
The following details what is displayed:
802.1x Enabled/Disabled − Shows the current status of 802.1x
functions on the switch.
Authentication Protocol: Radius_Eap − Shows the authentication
protocol suite in use between the switch and a Radius server.
Port number − Shows the physical port number on the switch.
Capability: Authenticator/None − Shows the capability of 802.1x
functions on the port number displayed above. There are two 802.1x
capabilities that can be set on the switch: Authenticator and None.
AdminCtlDir: Both/In − Shows whether a controlled Port that is
unauthorized will exert control over communication in both receiving
and transmitting directions, or just the receiving direction.
OpenCtlDir: Both/In − Shows whether a controlled Port that is
unauthorized will exert control over communication in both receiving
and transmitting directions, or just the receiving direction.
Port Control: ForceAuth/ForceUnauth/Auto − Shows the
administrative control over the port's authorization status. ForceAuth
forces the Authenticator of the port to become Authorized.
ForceUnauth forces the port to become Unauthorized.
QuietPeriod − Shows the time interval between authentication failure
and the start of a new authentication attempt.
TxPeriod − Shows the time to wait for a response from a supplicant
(user) to send EAP Request/Identity packets.
SuppTimeout − Shows the time to wait for a response from a
supplicant (user) for all EAP packets, except for the Request/Identity
packets.
ServerTimeout − Shows the length of time to wait for a response from
a RADIUS server.
MaxReq − Shows the maximum number of times to retry sending
packets to the supplicant.
DGS-3212SR Layer 3 Gigabit Switch
195