D-Link DGS-3212SR Command Line Interface Reference Manual page 72

show packet ports
Restrictions
Example usage:
To display the packets analysis for port 7 of module 2:
DGS-3212SR:4#show packet port 2:7
Port number : 2:7
Frame Size
------------
64
65-127
128-255
256-511
512-1023
1024-1518
Unicast RX
Multicast RX
Broadcast RX
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
show error ports
Purpose
Syntax
Description
Parameters
DGS-3212SR Layer 3 Gigabit Switch
port number on that switch, separated by a colon. Then the
highest switch number, and the highest port number of the range
(also separated by a colon) are specified. The beginning and end
of the port list range are separated by a dash. For example, 1:3
specifies switch number 1, port 3. 2:4 specifies switch number 2,
port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3
and switch 2, port 4 − in numerical order.
None.
Frame Counts Frames/sec Frame Type Total
------------ ----------
3275 10
755 10
316 1
145 0
15 0
0 0
152 1
557 2
3686 16
Used to display the error statistics for a range of ports.
show error ports <portlist>
This command will display all of the packet error statistics
collected and logged by the switch for a given port list.
<portlist> − Specifies a range of ports to be displayed. The port
list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon.
Then the highest switch number, and the highest port number of
the range (also separated by a colon) are specified. The
beginning and end of the port list range are separated by a dash.
60
---------- -------
RX Bytes 408973 1657
RX Frames 4395
TX Bytes 7918
TX Frames 111
Total/sec
---------
19
178
2