D-Link DGS-3212SR Command Line Interface Reference Manual page 182

show authen server_host
Description
Parameters
Restrictions
Example usage:
To view authentication server hosts currently set on the switch:
DGS-3212SR:4#show authen server_host
Command: show authen server_host
IP Address Protocol
---------------
10.53.13.94 TACACS
Total Entries : 1
DGS-3212SR:4#
create authen server_group
Purpose
Syntax
Description
DGS-3212SR Layer 3 Gigabit Switch
This command is used to view user-defined authentication server
hosts previously created on the switch.
The following parameters are displayed:
IP address – The IP address of the authentication server host.
Protocol – The protocol used by the server host. Possible results will
include tacacs, xtacacs, tacacs+ and radius.
Port – The virtual port number on the server host. The default value is
49.
Timeout - The time in seconds the switch will wait for the server host
to reply to an authentication request.
Retransmit - The value in the retransmit field denotes how many
times the device will resend an authentication request when the
TACACS server does not respond. This field is inoperable for the
tacacs+ protocol.
Key - Authentication key to be shared with a configured TACACS+
server only.
None.
Only administrator-level users can issue this command.
Port Timeout Retransmit Key
-------- ----- -------
49 5
Used to create a user-defined authentication server group.
create authen server_group <string 15>
This command will create an authentication server group. A server
group is a technique used to group
--------------- --------
2 No Use
170