Setting Failsafe Mode - Honeywell UDC2300 Product Manual

6.13 Setting Failsafe Mode

Introduction
You can set the Failsafe Mode to be Latching or Non-Latching.
Set Failsafe Mode
Table 6-16 Procedure for Setting a Failsafe Mode
Step Operation
Select Control
1
Set-up Group
2 Select Failsafe
Function Prompt
Select a value
3
Return to Normal
4
Display
12/00
Press
Until you see:
SET UP
Upper Display = SET
Lower Display = CONTRL
FUNCTION You will see:
Upper Display =
LACH (Controller goes to manual and output goes to
NO L (Controller mode does not change and output goes
Lower Display = FSMODE
[ ] [ ] To select a failsafe mode in the upper display.
At power up, the output will go to the value set.
DISPLAY
UDC2300 Controller Product Manual
Result
failsafe value)
to failsafe value)
Operation
69