Table 5-3 Lower Display Key Parameter Prompts - Honeywell UDC2300 Product Manual

Monitoring
Viewing the operating parameters
Press the
DISPLAY
lower display will show only those parameters and their values that apply to your specific
model.

Table 5-3 Lower Display Key Parameter Prompts

Lower Display
OT
SP
2L
RS
2ND
DE
PIDSX
RPXXXM
AX
Sn
BI
To BGn
50
key to scroll through the operating parameters listed in Table 5-3. The
OUTPUT—Output value is percent; for Three Position Step control, this is an
estimated motor position when no slidewire exists.
LOCAL SETPOINT #1—Also current setpoint when using SP Ramp.
LOCAL SETPOINT #2
REMOTE SETPOINT
INPUT 2
DEVIATION—Maximum negative display is –999.9.
TUNING PARAMETER SELECTED SET—where X is either 1 or 2.
TIME REMAINING—Time that remains on timer in Hours.Minutes
ELAPSED TIME—Time that has elapsed on timer in Hours.Minutes.
SETPOINT RAMP TIME—Time remaining in the setpoint ramp in minutes.
AUXILIARY OUTPUT
SP RATE SETPOINT—Current setpoint for setpoint rate applications
BIAS—Displays the manual reset value for algorithm PD+MR.
TO BEGIN—Resets Setpoint Program back to beginning of the program.
UDC2300 Controller Product Manual
Description
12/00