Honeywell UDC2300 Product Manual page 164

Function Parameter Reference Guide
12.2.93 SPPROG
This prompt is part of the Setpoint Ramp/Program Set up group.
This selection allows you to disable/enable the Setpoint Ramp/Soak Program function.
"SPRAMP" and "SPRATE" must be disabled.
Selections
DIS Disables the Ramp/Soak Program Function. Allows "SPRAMP" or
"SPRATE" option to be selected.
ENAB Enables the setpoint Ramp/Soak Program Function.
12.2.94 SPRAMP
This prompt is part of the Setpoint Ramp/Program Set up group.
This selection allows you to disable/enable the Setpoint Ramp function.
Make sure you configure a ramp time (TI MIN) and a final setpoint value (FINLSP).
"SPPROG" and "SPRATE" must be disabled.
Selections
DIS Disables the Setpoint Select Function. Allows "SPPROG" or "SPRATE"
option to be selected.
ENAB Enables the Setpoint Select Function.
12.2.95 SPRATE
This prompt is part of the Setpoint Ramp/Program Set up group.
This selection allows you to configure a specific rate of change for any local setpoint
change.
"SPRAMP" and "SPPROG" must be disabled
Selections
DIS Disables the Setpoint Rate option.
ENAB
Enables the Setpoint Rate option. SP Rate parameters
154
(SETPOINT RAMP/SOAK PROGRAM)
Definitions
(SINGLE SETPOINT RAMP)
Definitions
(SETPOINT RATE)
Definitions
(EUHRUP, EUHRDN) appear when Rate is enabled.
UDC2300 Controller Product Manual 12/00