EAGLE CONTROLLER
6. Push the rotate&push button. The datapoint status is displayed.
7. Push the rotate&push button. The Manual checkbox is disabled.
8. Turn the rotate&push button to navigate to and highlight Back, or press the
Back operating key
screen redisplays. The edited datapoint is no longer in the list.
NOTE: When updating the controller firmware via CARE, datapoints will be
Purpose
Sets a datapoint into manual mode and changes its value.
Procedure
1. In the Home screen, turn the rotate&push button to navigate to and highlight
Main Menu
2. Then push the rotate&push button. The MAIN MENU is displayed.
on the controller housing. The DATA POINT LIST
hidden on the HMI if the read access level of the current HMI user is
lower than the read access level specified in CARE.
.
53
BASIC OPERATION PROCEDURES
Setting Datapoint into Manual Mode
EN2Z-0971GE51 R0515