Honeywell UDC2300 Product Manual page 148

Function Parameter Reference Guide
12.2.49 IN1TYP
This prompt is part of the Input 1 Set up group.
This selection determines what actuation you are going to use for Input 1.
ATTENTION
Changing the input type will result in the loss of Field Calibration values and will restore Factory
Calibration values.
Selections
B B—B Thermocouple
E H E H—E Thermocouple High
E L E L—E Thermocouple Low
J H J H—J Thermocouple High
J L J H—J Thermocouple Low
K H K H—K Thermocouple High
K L K H—K Thermocouple Low
NNMH NNMH—Ni-Ni-Moly Thermocouple High
NNML NNML—Ni-Ni-Moly Thermocouple Low
N90H N90H—NiMo-NiCo Thermocouple High
N90L N90L—NiMo-NiCo Thermocouple Low
NIC NIC—Nicrosil-Nisil Thermocouple
R R—R Thermocouple
S S—S Thermocouple
T H T H—T Thermocouple High
T L T L—T Thermocouple Low
W H W H—W5W26 Thermocouple High
W L W L—W5W26 Thermocouple Low
100H 100H—100 Ohm RTD High
100L 100L—100 Ohm RTD Low
200 200—200 Ohm RTD
500 500—500 Ohm RTD
RADH RADH—Radiamatic RH
RADI RADI—Radiamatic RI
0-20 0-20—0 to 20 Milliamperes
4-20 4-20—4 to 20 Milliamperes
10m 10m—0 to 10 Millivolts
50m 50m—0 to 50 Millivolts
0-5 0-5—0 to 5 Volts
1-5 1-5—1 to 5 Volts
0-10 0-10—0 to 10 Volts
100m 100m—0 to 100 Millivolts
138
(INPUT 1 ACTUATION TYPE)
Definitions
UDC2300 Controller Product Manual 12/00