Timer - Honeywell UDC2300 Product Manual

Switching between setpoints
You can switch Local and Remote setpoints or between two Local setpoints when
configured.
ATTENTION
Table 6-6 Procedure for Switching Between Setpoints
Step Operation
Select the
1
Setpoint

6.6 Timer

Introduction
The Timer provides a configurable Time-out period of from 0 to 99 hours:59 minutes or 0
to 99 minutes:99 seconds.
Timer "Start" is selectable as either the
The Timer display can be either "Time Remaining" or "Elapsed Time".
Configuration check
Make sure:
• TIMER is enabled
• A TIMEOUT period has been selected (in hours and minutes or minutes and
seconds)
• A TIMER FUNCTION START has been selected (KEY or AL2)
• A TIMER display has been selected (Time remaining or Elapsed time)
• A timer increment selected
• Timer reset selected
Refer to Subsection 4.4 - Timer Set Up Group for details.
12/00
The REMOTE SETPOINT value cannot be changed at the keyboard.
Press
To alternately select Local Setpoint 1 (LSP) and the Remote
FUNCTION
Setpoint (RSP) or switch between the 2 Local Setpoints (LSP
and 2L)
ATTENTION "KEY ERROR" will appear in the
lower display, if:
• the remote setpoint or 2
• you attempt to change the setpoint while a setpoint ramp
• if you attempt to change the setpoint with the setpoint
UDC2300 Controller Product Manual
as a setpoint source
is enabled, or
select function key disabled.
key or Alarm 2.
RUN/HOLD
Result
nd
local setpoint is not configured
Operation
59