Honeywell UDC2300 Product Manual page 160

Function Parameter Reference Guide
12.2.79 RESET
This prompt is part of the Timer Set Up group.
This selection determines how the timer will be reset.
Selections
KEY Run/Hold key.
AL1 Alarm 1
12.2.80 RN HLD
This prompt is part of the Tuning Set up group.
This selection allows you to disable/enable the Setpoint Ramp/Program
"LOCK" must be set to "None".
Selections
DIS Disable the
ENAB Enables the
12.2.81 RPUNIT
This prompt is part of the Setpoint Ramp/Program Set up group.
This selection determines the engineering units for ramp segments.
Selections
TIME
Hours:Minutes
EU-M
Rate - Engineering units per minute
EU-H Rate - Engineering units per hour
12.2.82 RSPSRC
This prompt is part of the Control Set up group.
This selection determines what your Remote setpoint source will be when toggled by the
key or Digital Input.
FUNCTION
Selections
NONE NONE—No remote setpoint.
INP2
INPUT 2—Remote Setpoint is Input 2.
150
(TIMER RESET CONTROL)
Definitions
(RUN/HOLD KEY LOCKOUT)
Definitions
key
RUN/HOLD
key
RUN/HOLD
(ENGINEERING UNITS FOR RAMP SEGMENTS)
Definitions
(REMOTE SETPOINT SOURCE)
Definitions
UDC2300 Controller Product Manual
key.
RUN/HOLD
12/00