Honeywell UDC2300 Product Manual page 144

Function Parameter Reference Guide
12.2.36 FAILSF
This prompt is part of the Control Set up group.
The value used here will also be the output level when Input 1 fails for all inputs except
T/C, or when NO BURNOUT is configured and input 1 fails for T/C Inputs.
Range of Setting:
12.2.37 FILTR1
This prompt is part of the Input 1 Set up group.
A software digital filter is provided for input 1 to smooth the input signal. You can
configure the first order lag time constant from 1 second to 120 seconds. If you do not
want filtering, enter 0.
Range of Setting: 1 to 120
12.2.38 FILTR2
This prompt is part of the Input 2 Set up group.
A software digital filter is provided for input 2 to smooth the input signal. You can
configure the first order lag time constant from 1 second to 120 seconds. If you do not
want filtering, enter 0.
Range of Setting: 1 to 120
12.2.39 FINLSP
This prompt is part of the Setpoint Ramp/Program Set up group.
Enter the value desired for the final setpoint. The controller will operate at the setpoint set
here when ramp is ended.
ATTENTION
If the ramp is on HOLD, the held setpoint can be changed by the increment or decrement keys.
However, the ramp time remaining and original ramp rate is not changed. Therefore, when
returning to RUN mode, the setpoint will ramp at the same rate as previous to the local setpoint
change and will stop if the final setpoint is reached before the time expires. If the time expires
before the final setpoint is reached, it will jump to the final setpoint.
Range of Setting: within the setpoint limits
134
(FAILSAFE OUTPUT VALUE)
0 to 100 %
For 3 Position Step
100 - Motor position set to 100 % output position (open)
0 - Motor position set to 0 % output position (closed)
(INPUT 1 FILTER)
0 = No Filter
(INPUT 2 FILTER)
0 = No Filter
(SINGLE SETPOINT RAMP FINAL SETPOINT)
UDC2300 Controller Product Manual 12/00