Input Calibration - Honeywell UDC2300 Product Manual

8.1 Overview
Introduction
This section describes the field calibration procedures for Input 1 and Input 2.
• Every UDC2300 controller contains all input actuation ranges which are fully factory-
calibrated and ready for configuration to range by the user.
• However, these procedures can be implemented if the factory calibration of the
desired range is not within specification.
CAUTION
The field calibration will be lost if a change in input type configuration is implemented at a later
time. The original factory calibration data remains available for later use after a field calibration is
done. See subsection 8.8 if you want to restore factory calibration values.
What's in this section?
The following topics are covered in this section.
8.1 Overview
8.2 Minimum and Maximum Range Values
8.3 Preliminary Information
8.4 Input #1 Set Up Wiring
8.5 Input #1 Calibration Procedure
0 Input #2 Set Up Wiring
8.7 Input #2 Calibration Procedure
8.8 Restore Factory Calibration
INPUT CALIBRATION MAY REQUIRE ACCESS TO HAZARDOUS LIVE CIRCUITS, AND
SHOULD ONLY BE PERFORMED BY QUALIFIED SERVICE PERSONNEL. MORE THAN
ONE SWITCH MAY BE REQUIRED TO DE-ENERGIZE UNIT BEFORE CALIBRATION.
12/00

8 Input Calibration

TOPIC
WARNING—SHOCK HAZARD
UDC2300 Controller Product Manual
Input Calibration
See Page
83
84
85
87
89
91
92
93
!
83