Lockout Feature - Honeywell UDC2300 Product Manual

Step Operation
Enter Set Up
1
Mode
Select any Set Up
2
Group
3 Security Code
Entry

5.4 Lockout Feature

Introduction
The lockout feature in the UDC2300 is used to inhibit changes (via keyboard) of certain
functions or parameters by unauthorized personnel.
Lockout levels
There are different levels of Lockout depending on the level of security required. These
levels are:
• NONE
• CAL
• CONF
• VIEW
• ALL
See Subsection 4.5 - Tuning Parameters Set Up Group prompts to select one of the
above.
Security Code (see Subsection 5.3)
12/00
Table 5-1 Procedure to Enter a Security Code
Press
Upper Display = SET UP
SET UP
Lower Display = TUNING
Upper Display = 0
FUNCTION
Lower Display = SECUR
[ ] [ ] To enter a four digit number in the upper display
This will be your security code.
No Lockout. All groups Read/Write.
Calibration prompts are deleted from the Setup List.
Timer, Tuning, SP Ramp, and Accutune are Read/Write. All other Setup
groups are Read only. Calibration Group is not available.
Timer, Tuning, and SP Ramp are Read/Write. No other parameters are
available.
Timer, Tuning, and SP Ramp are Read only. No other parameters are
viewable.
UDC2300 Controller Product Manual
Result
(0001 to 4095)
Monitoring
47