View Firmware Version Of The Cpu; Connection Test; View Serial Number; Compile Time - Lightware MMX4x2-HT200 User Manual


  
6. LW2 Programmers' Reference
6.2.3. View Firmware Version of the CPU
Description: View the CPU firmware revision.
Format
Command {F}
Response (FW:<FW_VER><s>)CrLf
Legend: <FW_VER> is the firmware version. It is followed by <s> string which may indicate special versions.
6.2.4. Connection Test
Description: Simple test to see if the connection is established successfully.
Format
Command {PING}
Response (PONG!)CrLf
6.2.5. View Serial Number
Description: The device responds its 8-digit serial number.
Format
Command {S}
Response (SN:<SERIAL_N>)CrLf
6.2.6. Compile Time
Description: Returns the date, when the CPU firmware was compiled.
Format
Command {CT}
Response (Complied: <DATE&TIME>)CrLf
6.2.7. View Installed Board
Description: Shows the hardware name and revision of the installed cards.
Format
Command {IS}
Response (SL#●0●<MB_DESC>)CrLf
(SL●END)CrLf
Explanation: The device reports its motherboard (slot 0).
Example
 {f}
 (FW:1.2.0b3)
Example
 {ping}
 (PONG!)
Example
 {s}
 (SN:5A004254)
Example
 {ct}
 (Compiled: Sep 30 2016 14:07:56)
Example
 {is}
 (SL# 0 MMX4x2-HT200 V12_DAA0)
 (SL END)
MMX4x2 series – User's Manual
6.2.8. View Firmware for All Controllers
Description: Shows the firmware versions of all installed controllers.
Format
Command {FC}
Response (CF●<DESC>)CrLf
(CF●<DESC>)CrLf
...
(CF END)CrLf
Explanation: The device has one control panel.
6.2.9. Restart the Device
Description: The device can be restarted without unplugging power.
Format
Command {RST}
Response
Explanation: The device reboots; no response is sent in this case.
6.2.10. Query Health Status
Description: Internal voltages and measured temperature values are shown.
Format
Command {ST}
Response (ST●<DESC>)CrLf
6.2.11. Restore Factory Default Settings
Description: Settings can be reset to factory default values as follows:
Format
Command {FACTORY=ALL}
Response (FACTORY ALL...)CrLf
Explanation: All settings and parameters are reset to factory default, see the table in the
Settings section.
Example
 {fc}
 (CF MMX4x2-HT200 1.2.0b3)
 (SL END)
Example
 {rst}
Example
 {st}
 (ST CPU 12.16V 5.03V 3.30V 3.33V 3.37V
1.30V 1.86V 1.00V 53.22C 53.26C)
Example
 {factory=all}
 (FACTORY ALL...)
Factory Default
43