Table of Contents
Advertisement
5.12.5 Arm/Disarm the System using a LCD Reader
New model of readers, ERL-871 in EverAccess series was released to provide a more intuitive user
interface to interact with the system. ERL-871 provides a large LCD to show more information from
controller.
The steps to arm/disarm system with ERL-871 are explained below:
1. Press "*" on keypad, input 8 digits ARM password and press "#" to confirm.
2. After entered the ARM menu, press "#" key to arm/disarm the system. Press "*" to exit the
system.
5.13 Use Reader as Keypad
Access control system provides a keypad to control a door and approve or deny an access request. NAV
Controller provides the same function with the correct setting.
To use PIN only to access a door, set the door verification mode as "Card or PIN or fingerprint", and set
the keypad reader with the enabled keypad property. When these setting are all configured right, users
can key in the valid card PIN at the keypad reader and press # to gain the access. If the PIN matches the
records in the system and the door verification mode allows, the controller will unlock the door.
Take the operation on ERL871 LCD keypad reader as example, the steps to use PIN only to access are
listed below:
1. Press any numeric key on ERL871 keypad, the below screen will show and the first inputted key
will be stored there already:
2. Press "#" key to confirm the inputted PIN. If the PIN is verified OK, the below screen will be
shown. If PIN retry failed 3 times, system will show "ERR" on screen and return to the main page
of ERL871.
2009-02-01
09:38
Input Password:
________
2009-02-01
09:38
System disarmed
[ENT] to toggle
2009-02-01
09:38
Input password:
*_______
2009-02-01
09:38
********
Access Granted
61
NAV IP Access Controller
Advertisement
Table of Contents
