Table of Contents
Advertisement
3. Install and mount additional door modules or the alarm module.
Note: The controller can hook up to 4 door modules and only 1 alarm module. Each
door module is cascaded to its left side module till the main module. The door
modules and the alarm module can be placed in any sequence.
a.
Connect the pins on the lower right corner of the new module to the connector
on the bottom left corner of the installed module. Make sure that the pins fit
snugly into the receiving module.
b. Secure the module to the controller base board using the three screws provided
in the module package.
Figure 2-4
Figure 2-5
15
NAV IP Access Controller
Advertisement
Table of Contents
